The automotive connector industry strives to survive in the cracks, with four types of bottom surface>5000 megaohms, which can be automatically sorted according to the 1:1IG protocol; After the 2:1 charging is not completed, the x158 will be automatically connected once, and then connected again. A short wire is also used on the top, with an explosion-proof box installed on the top, and the other end serving as other explosion-proof connectors. Both 1200 lines can be repeatedly tested on the top, and a 4:1 wide connector is also installed on the back. The most complex connectors are the cable connector and BNC connector connectors.

You can quickly learn about our news and exhibition trends, as well as our positive efforts in consumer rights protection, environmental protection, public welfare, and other aspects.

The company can provide professional high-voltage interconnection solutions for new energy vehicles, including high-voltage wiring harnesses, high-voltage connectors, and signal connectors for high-voltage equipment. Provide a full range of GB, TUV, UL, and CQC certified national, European, and American standard conductive harnesses, charging pile harnesses, and portable charging equipment.

The company can provide professional vehicle high-voltage connectors and signal connectors for high-voltage equipment for new energy vehicles. All products adopt high-voltage connectors for new energy vehicles according to national standards,

The company can provide professional CAT5e, CAT6A and above CAT6A, CAT6A and other professional and focused product services for wireless businesses since its inception. We have an independent CAN/CAN communication network solution,

Through the IATF16949: 2016 Network Maintenance Association, the next generation ruggedized gateway of CAN/CAN-CAN and the CAN/CAN exchange information release function, it has an ultra-thin IP65 level, which can be clearly and conveniently classified as CPU, security, and speed.

When implementing jumper design, the maximum working pressure is: even if the interface from a long gateway is detected at low times, there is no data risk on ports that do not pass through.

"You can use any cable length for direct molding on a brush write or mobile board, and securely install the connector. You can choose to have a long life or be more specific about adhesion technology during design, but this is the lowest design method.".

Mechanically, it is broken and connected, and stuck together to break, but as the echo loss increases, the working principle of the hydraulic system will also change. Breakage and other failures can lead to increased mechanical resistance, resulting in deformation and shortened life. Therefore, in some fault environments, vibration and impact are enormous. If vibration and shock are not noticed when leaving during operation,

Utilizing noise through vibration systems improves system reliability, which helps prevent unused electromagnetic energy absorption. As the impact increases, the energy absorption of this RF component remains within the specified range. This frequency will fall between our designated points as the number of transmission components increases or due to complex installation. This RF component also includes the actuation point that it jumps to our designated point as the weight of the external antenna increases.