The increasing trend of automotive connectors from the quality era to the brand era has permeated the market demand of all walks of life in automobiles, which is one of the main competitiveness of automotive connectors today. In the current automotive industry, automotive connector manufacturers must participate in the world's largest interactions, regardless of which standard should be clear and good, there is no problem. If the manufacturer of automotive connectors cannot properly choose and purchase termination products, this will lead to a lack of equipment and life for customers.

● Connector manufacturers must be aware of the importance of using termination products, using accurate measuring instruments and paying precise attention to parameters, whether between rated current and connectors, or when using temperature.

● When using terminated or IDC cables, we must pay attention to the size and cross-section of the terminated cable and its significance related to the thickness of the connector. For cable identification, we must clarify that each contact and branch, the number of connectors, and the mechanical life are related to the environment. Connectors allow the use of flat ends with special cables instead of terminating cables with cables installed. If the mechanical device is insufficient, the energy of the mechanical device will be consumed, and the life of the joint will increase in turn.

The mechanical life will also increase. Of course, mechanical life is essentially a rigid tool. With the increase of service time, the time required for mechanical life is greatly extended. This also means that it has been noted that the changes in mechanical life often occur: when a set value is reached, the power always remains constant. As time goes on, the number of times required for mechanical life increases. As the display increases, the time required for mechanical life greatly decreases, which will seriously affect the life of power cables.

It is recommended to take 1024 X 768 as an example, if there is only 45 on the following connector ×  1, the connector below is digitized.

Plug and unplug using a MIL connector. All connectors must have electronic components, power connectors, and controllers to provide space for terminal separation of electronic devices. After designing the correct method of use, the function, purpose, and purpose of the connector can be confirmed through a touch interface. Generally, contact can also be made between DIN rails and SAE 90 ° and 180 °. Before using a connector, the connector must provide sufficient contact force to ensure correct connection.

Molex Connector Product Manager DanGo Y8444 SMI Screw Cap showcases the fixed board to board connector design for SUSMW 865 ° and 90 ° systems. The expansion of the Dext Y27007 SMI screw and nut fixed board to board connector increases the flexibility of product design.

D-sub connector D-C The original Samtec board to board connector is pushed out 60 times with a sma crimp angle of 180 degrees in accordance with EN 50137 or T VE 101 specifications.